They should be position in the following spots.
Grab bar placement in tub shower.
On the wall at the entrance to the shower stall.
It is suggested that you should install a minimum of two grab bars in you shower bathtub.
Unlike a diagonal or vertical placement horizontally positioning of the grab rail provides a hand hold at one pre determined height.
Two grab bars shall be installed on the back wall one located in accordance with 609 4 and the other located 8 inches 205 mm minimum and 10 inches 255 mm maximum above the rim of the bathtub.
These are minimum suggestions.
Ask the user if he has a preference of a longer or shorter bar.
Grab bars shall not be provided above the seat.
You can mount a grab bar horizontally vertically and diagonally.
Again another small bar positioned.
Grab bars in tub requirements bathtubs with permanent seats back wall.
Choose bars that are 1 1 2 inches.
Choose a bar 18 inches long or longer for vertical placement at the edge of the tub.
Attach a vertical grab bar near the tub edge following the procedures shown in photos 1 7.
The bottom of the shower bar should be about 32 in.
Each grab bar shall be installed 15 inches 380 mm maximum from the head end wall and 12 inches 305 mm maximum from the control end wall.
Choose a bar 32 inches long or longer for a horizontal bar.
On the side wall.
All three directions can be used in the tub.
Grab bars shall be installed 6 inches 150 mm maximum from adjacent walls.
When mounting at an angle be sure to locate the studs to fasten the bar to and measure accordingly.
Horizontal placement of a grab bar provides increased coverage in the horizontal plane.
Yank both grab bars to test for a strong connection.
Side wall horizontal or angled to assist with sitting and standing in the shower.
If you sit down on a shower chair diagonally may be the best direction for the bar nearest your chair.
Vertical grips are sold in lengths ranging from 12 to 24 inches according to the mr.
Front wall where the showerhead and controls are or assistance with getting in and out of the shower.
Grab bar and family handyman websites.
This is useful in situations where a lot of movement is anticipated and the shower is medium to large in size.
Alternate roll in type shower compartments in alternate roll in type shower compartments grab bars shall be provided on the back wall and the side wall farthest from the compartment entry.
You re not done until you yank test.
Vertical bars run up and down and typically are mounted at the entrance of the shower to stabilize a bather as he enters or exits.
This is normally a small grab bar positioned vertically.
By the faucet handles or near them.
